ocs_doc_api: Phase 2c-ii — dimension sub-types (radius/diameter/angular)

- CreateDimensionRadius/CreateDimensionDiameter (DimensionRadialSpec) +
  CreateDimensionAngular (DimensionAngularSpec) ops (append-only).
- backend add_dimension_radius/diameter (DimensionRadius/DimensionDiameter::new)
  + add_dimension_angular (DimensionAngular3Pt::new computes angle);
  dimension_measurement returns degrees for angular sub-types.
- facade create_dimension_radius/diameter/angular; spec constructors; api_reference
  + binding_schema regenerated; mocks + baseline.
- Test phase2cii_dimension_radius_diameter_angular -> 613 host lib + 3 consistency green.

crates/ocs_doc_api/src/gen/api_reference.md

@@ -133,6 +133,9 @@ Linear dimension between two measured points. measurement() reads the distance;
 ### Constructors (`doc.curves()`)
 
 - **create_dimension_linear**(first_point: [f64; 3], second_point: [f64; 3], definition_point: [f64; 3]) -> `Dimension` — `CreateDimensionLinear`
+- **create_dimension_radius**(center: [f64; 3], point: [f64; 3]) -> `Dimension` — `CreateDimensionRadius`
+- **create_dimension_diameter**(center: [f64; 3], point: [f64; 3]) -> `Dimension` — `CreateDimensionDiameter`
+- **create_dimension_angular**(vertex: [f64; 3], first_point: [f64; 3], second_point: [f64; 3], arc_location: [f64; 3]) -> `Dimension` — `CreateDimensionAngular`
 
 ### Methods
 

crates/ocs_doc_api/src/gen/ops_gen.rs

@@ -7,7 +7,7 @@
 use serde::{Deserialize, Serialize};
 
 use crate::id::ObjectId;
-use crate::ops::{BoolOp, Curve2Spec, DimensionSpec, EntitySpec, HatchSpec, InsertSpec, MTextSpec, PlacementSpec, RasterImageSpec, SolidPrimitive, TextSpec, ViewportSpec};
+use crate::ops::{BoolOp, Curve2Spec, DimensionAngularSpec, DimensionRadialSpec, DimensionSpec, EntitySpec, HatchSpec, InsertSpec, MTextSpec, PlacementSpec, RasterImageSpec, SolidPrimitive, TextSpec, ViewportSpec};
 
 /// A typed write operation (plan §5). Each variant is ONE atomic host call = one
 /// undo step. Append new variants at the END only.
@@ -48,4 +48,8 @@ pub enum Operation {
     CreateRasterImage(RasterImageSpec),
     // multi-profile solid
     Loft { profiles: Vec<ObjectId> },
+    // dimension sub-types
+    CreateDimensionRadius(DimensionRadialSpec),
+    CreateDimensionDiameter(DimensionRadialSpec),
+    CreateDimensionAngular(DimensionAngularSpec),
 }