//! Sketch creation families and the active part's last interactive variant. use std::collections::BTreeMap; use solidcraft_engine::CommandSpec; pub struct Family { pub label: &'static str, pub commands: &'static [&'static str], } pub const FAMILIES: &[Family] = &[ Family { label: "Line", commands: &["sketch.line", "sketch.line.midpoint"] }, Family { label: "Rectangle", commands: &["sketch.rectangle.two_point", "sketch.rectangle.three_point", "sketch.rectangle.center"] }, Family { label: "Circle", commands: &[ "sketch.circle.center", "sketch.circle.two_point", "sketch.circle.three_point", "sketch.circle.two_tangent", "sketch.circle.three_tangent", ], }, Family { label: "Arc", commands: &["sketch.arc.three_point", "sketch.arc.center_point", "sketch.arc.tangent"] }, Family { label: "Slot", commands: &[ "sketch.slot.center_to_center", "sketch.slot.overall", "sketch.slot.center_point", "sketch.slot.arc_three_point", "sketch.slot.arc_center", ], }, Family { label: "Polygon", commands: &["sketch.polygon.inscribed", "sketch.polygon.circumscribed", "sketch.polygon.edge"] }, Family { label: "Spline", commands: &["sketch.spline.fit_point", "sketch.spline.control_point", "sketch.spline.control_point_5"] }, ]; pub fn family(id: &str) -> Option<&'static Family> { FAMILIES.iter().find(|f| f.commands.contains(&id)) } /// UI state only, swapped with document tabs; never dirties the model or its undo history. #[derive(Clone, Debug, Default)] pub struct Choices(BTreeMap<&'static str, &'static str>); impl Choices { pub fn remember(&mut self, id: &str) { if let Some(f) = family(id) && let Some(id) = f.commands.iter().find(|c| **c == id) { self.0.insert(f.label, id); } } pub fn selected(&self, f: &Family) -> Option<&'static CommandSpec> { self.0.get(f.label).copied().or_else(|| f.commands.first().copied()).and_then(solidcraft_engine::find_command) } } #[cfg(test)] mod tests { use super::*; #[test] fn families_are_disjoint_registered_creation_commands() { let mut seen = std::collections::BTreeSet::new(); for f in FAMILIES { assert!(!f.commands.is_empty()); for id in f.commands { assert!(seen.insert(id), "duplicate variant {id}"); let c = solidcraft_engine::find_command(id).unwrap(); assert_eq!((c.tab, c.panel), ("SKETCH", "CREATE")); } } } #[test] fn choices_ignore_unknown_commands_and_keep_families_independent() { let mut choices = Choices::default(); choices.remember("sketch.rectangle.center"); choices.remember("sketch.circle.three_point"); choices.remember("sketch.rectangle.unknown"); for (id, expected) in [ ("sketch.rectangle.two_point", "sketch.rectangle.center"), ("sketch.circle.center", "sketch.circle.three_point"), ("sketch.line", "sketch.line"), ] { assert_eq!(choices.selected(family(id).unwrap()).unwrap().id, expected); } } }