{
  "source": "analytic",
  "method": "contour flange, width 50 along +Y, XZ section: plate x 0..35 z 0..2.5; bend R 2.5..5 about (35, 5) (sketch corner = outer virtual sharp, setback R+t); wall x 37.5..40 z 5..27.5; bend R 2.5..5 about (42.5, 27.5) (sketch corner = inner virtual sharp, setback R); plate x 42.5..70 z 30..32.5",
  "body_count": 1,
  "volume_mm3": 12097.621556370217,
  "area_mm2": 10412.00210735098,
  "center_of_mass": [
    36.037689993681276,
    25.0,
    15.087581425863405
  ],
  "bbox": {
    "min": [
      0.0,
      0.0,
      0.0
    ],
    "max": [
      70.0,
      50.0,
      32.5
    ]
  },
  "note": "SolidCraft convention: the sketch lines are the sheet face away from the material (material right of travel); thickness grows to the material side"
}