{ "id": "80-fillet-taper-to-fit", "name": "Fillet tapered to the room along its edge", "description": "Plate whose top narrows from 20 mm (x = 0) to 2 mm (x = 40), 15 high; its top front edge filleted at 3 mm with fit: taper, the radius following the room where 3 doesn't fit.", "exercises": [ "extrude", "fillet", "fit taper" ], "units": { "length": "mm", "angle": "deg", "area": "mm2", "volume": "mm3" }, "conventions": { "world": "right-handed; Z up. XY/XZ/YZ are the origin planes.", "sketch_frame": "sketch-local 2D coords; world = plane.origin + x*plane.x_dir + y*plane.y_dir (origin in mm). Profile 'loops' list sketch entity ids.", "point_refs": "'.start' / '.end' / '.center' reuse (share) that existing sketch point; 'at' is its position when referenced.", "extrude_direction": "positive = along sketch plane normal unless stated", "selections": "selected faces/edges carry 'point': a world-space point on the face / the edge's parametric midpoint; pick the nearest face/edge to it." }, "parameters": [], "features": [ { "op": "sketch", "name": "Extrude1_sketch", "plane": { "ref": "XY", "origin": [ 0.0, 0.0, 0.0 ], "x_dir": [ 1.0, 0.0, 0.0 ], "y_dir": [ 0.0, 1.0, 0.0 ], "normal": [ 0.0, 0.0, 1.0 ] }, "entities": [ { "type": "line", "start": { "at": [ 0, 0 ] }, "end": { "at": [ 40, 0 ] }, "id": "l1" }, { "type": "line", "start": { "ref": "l1.end", "at": [ 40.0, 0.0 ] }, "end": { "at": [ 40, 2 ] }, "id": "l2" }, { "type": "line", "start": { "ref": "l2.end", "at": [ 40.0, 2.0 ] }, "end": { "at": [ 0, 20 ] }, "id": "l3" }, { "type": "line", "start": { "ref": "l3.end", "at": [ 0.0, 20.0 ] }, "end": { "ref": "l1.start", "at": [ 0.0, 0.0 ] }, "id": "l4" } ], "constraints": [], "dimensions": [] }, { "op": "extrude", "name": "Extrude1", "operation": "new", "profiles": [ { "sketch": "Extrude1_sketch", "loops": [ { "outer": true, "curves": [ "l1", "l2", "l3", "l4" ] } ] } ], "extent": { "type": "distance", "distance": 15, "direction": "positive" }, "result_bodies": [ "Part" ] }, { "op": "fillet", "name": "Fillet1", "radius": 3.0, "fit": "taper", "edges": [ { "type": "line", "start": [ 0.0, 0.0, 15.0 ], "end": [ 40.0, 0.0, 15.0 ], "point": [ 20.0, 0.0, 15.0 ] } ] } ] }