bherbruckandClaude Opus 5.5 1c12fa83b0 Holes: a tapped hole takes the tap drill of its thread (major − pitch) when no diameter is given, and clearance: "M6" (fit close, normal or loose) gives the ISO 273 clearance diameter ...

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01AS5Tn3xieewUSg3uxrMVdL

2026-10-08 12:24:04 +00:00

..

cmd

Holes: a tapped hole takes the tap drill of its thread (major − pitch) when no diameter is given, and clearance: "M6" (fit close, normal or loose) gives the ISO 273 clearance diameter

2026-10-08 12:24:04 +00:00

lib.rs

Never lose work: atomic saves (temporary file, flush, rename) keeping the replaced version as <file>.bak; autosave of unsaved changes into a recovery folder (every 5 min, preference autosave_minutes, and after commands over 1.5 s; skipped when unchanged; entries locked while their app runs); Recover unsaved design? at launch; doc.recovery_list / doc.recover / doc.recovery_discard; kill-mid-save test

2026-10-08 11:37:33 +00:00

params.rs

M0: engine command registry, file formats, view math and CPU renderer

2026-10-07 17:30:37 +00:00

recovery.rs

Never lose work: atomic saves (temporary file, flush, rename) keeping the replaced version as <file>.bak; autosave of unsaved changes into a recovery folder (every 5 min, preference autosave_minutes, and after commands over 1.5 s; skipped when unchanged; entries locked while their app runs); Recover unsaved design? at launch; doc.recovery_list / doc.recover / doc.recovery_discard; kill-mid-save test

2026-10-08 11:37:33 +00:00

sample.rs

Start page and document tabs

2026-10-08 09:23:46 +00:00

tests.rs

Holes: a tapped hole takes the tap drill of its thread (major − pitch) when no diameter is given, and clearance: "M6" (fit close, normal or loose) gives the ISO 273 clearance diameter

2026-10-08 12:24:04 +00:00

view.rs

3D sketch: with 3D Sketch on, the Line, Spline and Point tools take points off the sketch plane, snapping to model vertices, edges and faces and to drawn 3D points (segments that stay on the plane are ordinary sketch lines); drawn 3D curves are wires with fit points (sketch.line3d, sketch.spline3d: centripetal Catmull-Rom, sketch.point3d), a clicked 3D point gets a move triad (drag along X/Y/Z or parallel to the sketch plane: sketch.move3d, joined ends move together), Delete removes it; sweep and pipe paths may mix 3D curves with sketch curves; control: ui.triad, ui.worldToScreen

2026-10-08 08:39:22 +00:00