format_length rounded the fraction after splitting the whole part off, so a
value that rounded up to a full unit had nowhere to go:
fractional 5.995 -> 5 (64/64 reduced to 1/1, then dropped)
fractional 0.995 -> 0
architectural 11.999 -> 0'-11"
architectural 23.999 -> 1'-11"
engineering 11.99 -> 0'-12.0" (twelve inches is a foot)
engineering 23.99 -> 1'-12.0"
Round once, into the smallest unit that will be shown, then split feet and
whole inches out of the rounded total. The carry reaches every column, so
the same values now read 6, 1, 1'-0", 2'-0", 1'-0.0" and 2'-0.0".
Saving to a path that already holds a drawing fails on Windows with
"could not verify <path> before saving: ... (os error 33)". Save As over any
existing drawing is affected; saving to a new path is not.
EditLease::acquire() opens the destination and takes the platform drawing
lock on it, then the save fingerprints the same path to check nothing changed
underneath. LockFileEx is mandatory and scoped to the handle that took it, so
that second open is refused against our own lock, lands in the non-NotFound
arm and aborts the save. flock on Unix is advisory and the second open
succeeds, so neither CI nor a Linux desktop sees it.
Read through the handle the lease already holds instead. A duplicate shares
the lock ownership, so the pre-replace re-check on the save worker can use
one too rather than re-opening the path.
The same collision reached the headless open op, which read a path this
session may hold leased: automation's save_then_open_round_trips fails on
main for that reason, one line after the save it no longer reaches.
A unitless block has no source length to convert from, so falling back to
MEASUREMENT gave it an inches or millimetres identity it never had and
scaled the reference on insert. The properties panel reported unit_factor
1.0 for the same insert.
Skip the conversion when either the block or the drawing is unitless.
Fixes#706.