bherbruck 71a4f3061b Fix document and toolbar tab styling

2026-10-10 18:00:37 -04:00

..

doc

Extrude's start_offset says which way it goes: along the sketch normal, also with direction: negative (where a positive offset starts on the far side of the sketch from the extrusion)

2026-10-10 17:57:34 -04:00

engine

Extrude's start_offset says which way it goes: along the sketch normal, also with direction: negative (where a positive offset starts on the far side of the sketch from the extrusion)

2026-10-10 17:57:34 -04:00

geom

fix: select complete circular rims and curved surfaces in 3D

2026-10-10 17:13:36 -04:00

io

Variable-radius and chord-length fillets

2026-10-08 21:30:58 +00:00

kernel

A sweep along a path with sharp corners follows the corners: sweeping a rim profile along three lines (an open rectangle) gave a body of volume -0.0006 mm3 with its centre of mass at x = -3.5e9, and no error

2026-10-10 17:57:34 -04:00

mcp

A failed MCP batch goes back to where it started however long the undo history is: rollback undid as many steps as the undo history had grown, but the history is capped at 200 steps, so once it was full a failed batch reported undone: 0 and left its sketches behind (an empty Sketch1, two sketches named TapHole). New commands edit.checkpoint and edit.restore_checkpoint (forget: true drops one) remember and restore the design, the active sketch and the undo history; batch takes a checkpoint before its first step, restores it on a failure and forgets it on success. Against an app without checkpoints batch falls back to counting undo steps

2026-10-10 17:21:25 -04:00

render

Section Analysis: cut faces in their body's colour (tinted toward the cap colour) and hatched; snapshots show the section too (the cut part removed, hatched cut faces)

2026-10-10 17:05:23 +00:00

sketch

Fix viewport input leaking through dialogs

2026-10-10 17:34:14 -04:00

ui-egui

Fix document and toolbar tab styling

2026-10-10 18:00:37 -04:00